1 / 6
Tesla logo added to trash can lid and fixed the problem with the can falling over/sliding. — zdjęcie 1
1 / 6

Tesla logo added to trash can lid and fixed the problem with the can falling over/sliding.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I wanted to add the Tesla logo to the top of this trash can lid and add magnets to the base to hold it to the floor mat.

Ocena
0 / 5
Polubienia
5
Pobrania
17
Wydruki
0
Wyświetlenia
147
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Share Alike

Added the Tesla logo to the lid. Printed with Prusa XL using PCTG/PETG

I have the all weather floor mats in my car so the spiked feet didn't hold very well.  I added magnets to the base and put a piece of sheet metal under the floor mat and hold it in place. This has worked perfectly. I have a MYLR with acceleration boost, not one time has the can fell over even under full acceleration! 

I placed the magnets in the base of the can with super glue then set it on a 100C bed. I left it there too long which made the base warp slightly but it still works fine. 

If you have already made this can throw some magnets in the bottom and a piece of sheet metal under the floor mat. You will thank me later.

Tagi