1 / 2
Eureka Specialita - Naked Portafilter and load cell holder — zdjęcie 1
1 / 2

Eureka Specialita - Naked Portafilter and load cell holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This complements a grind-by-weight modification made to the Eureka Grinder, using a touch display and load cell.

Ocena
0 / 5
Polubienia
3
Pobrania
58
Wydruki
1
Wyświetlenia
473
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This model provides a cover for the electronics design laid out by @jaap in the GitHub repository: https://github.com/jaapp/smart-grind-by-weight

It is a variation of the original design by @jaap

It contains the load cell, load cell amplifier and provides a portafilter holder at an angle of 12.5-degrees so that the grinds will fall straight into the portafilter and allow the load cell to measure the change.

You will need a small countersunk screw (4-6g x 12-15mm) to hold the backplate to the grinder using the “fork-slot-insert”. Some short M2 bolts will be needed to secure the load cell to the back and 20mm M3 bolts will be needed to secure the load-cell cover and portafilter holder to the weight bearing end of the load cell. 

Note: The screw to hold the backplate needs some electrical tape over it to stop a short circuit on the load cell amplifier.

This is mostly printed with PETG at a high infill rate because it needs to be stiff to reduce vibrations.

There is another take on this at https://makerworld.com/en/models/2027665-grinder-scale-eureka-mignon-mod#profileId-2186256

Tagi