Eureka Specialita - Naked Portafilter and load cell holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This complements a grind-by-weight modification made to the Eureka Grinder, using a touch display and load cell.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 58
- Makes
- 1
- Views
- 464
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model provides a cover for the electronics design laid out by @jaap in the GitHub repository: https://github.com/jaapp/smart-grind-by-weight
It is a variation of the original design by @jaap
It contains the load cell, load cell amplifier and provides a portafilter holder at an angle of 12.5-degrees so that the grinds will fall straight into the portafilter and allow the load cell to measure the change.
You will need a small countersunk screw (4-6g x 12-15mm) to hold the backplate to the grinder using the “fork-slot-insert”. Some short M2 bolts will be needed to secure the load cell to the back and 20mm M3 bolts will be needed to secure the load-cell cover and portafilter holder to the weight bearing end of the load cell.
Note: The screw to hold the backplate needs some electrical tape over it to stop a short circuit on the load cell amplifier.
This is mostly printed with PETG at a high infill rate because it needs to be stiff to reduce vibrations.
There is another take on this at https://makerworld.com/en/models/2027665-grinder-scale-eureka-mignon-mod#profileId-2186256