Fanatec ClubSport DD/DD+ Adapter for Moza Stalks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your Moza Multi-function Stalks to a Fanatec Wheelbase. A 60mm shaft extension is required.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 429
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Share Alike
This adapter allows you to mount the Moza Multi-function Stalks onto a Fanatec ClubSport DD or DD+ wheelbase with QR2. A 60mm shaft extension is required. I used the ClubSport DD/DD+ Shaft Extension from Simube. Using a ClubSport Wheel Rim Classic 2 (35cm diameter) I can comfortably reach the turn signal stalk with my index finger while driving.
To my knowledge, the adapter should also fit other currently available Fanatec wheelbases, as they all share the same mounting hole measurements (M4, 56x100mm). Only the ClubSport DD/DD+ is slightly special due to the protruded area around the shaft. Make sure the outer QR2 ring is at least 10cm away from the wheelbase. This allows you to remove the wheel quite well without any additional tools. Please report back, if this adapter fits your wheelbase, so I can update the description.
Turn signal auto-cancel
To enable auto-canceling for the turn signal, glue the small plastic piece (included with the Moza Stalk) to the wheel-side QR2. It should protrude slightly past the end of the QR2. I had to shorten the plastic piece by about 5mm, otherwise it would get caught between the Moza Stalks housing and the QR2 extension. There is just not quite enough space between them. Be careful not to cut off too much. In my case, the auto-canceling pin ends up just in front of the QR2 base-side flange. With that done, auto-canceling works smoothly without any rubbing.
Printing instructions
I recommend printing this adapter in PETG or another tough, non-brittle filament. I would avoid PLA. Increase the number of perimeters and infill percentage. I used 3 perimeters and 30% infill.
You may need support for the overhangs around the screw holes. The heat-set insert version may not require any support, but the small recess by the Fanatec screw holes may not turn out perfectly, depending on your printer and slicer settings.
Note (HS version): The HS version goes below the recommended minimal wall thickness of 3.3mm for M6 inserts. The outer wall thickness is only ~2.5mm. Keep this in mind when considering the HS version.
Non-printed parts required
- 1x 60mm shaft extension (e.g. Simube ClubSport DD/DD+ Shaft Extension)
- 4x M6x20mm screws
- 3x M6x50mm screws
- 7x M6 washers (DIN 125, ~12mm outer diameter)
- 3x M6 hex nuts
For the HS version: Replace 3 washers and 3 hex nuts with 3 M6 heat-set inserts. Designed for Ruthex or CNC kitchen M6x12.7mm inserts with 8.7mm width.