Ender 3 Toothed Pulley Belt tensioner 2GT X axis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ender style belt tensioner for 2GT toothed pulley. Suit Ender 3v2 or others with same gantry plates.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 131
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I had a few goes at making a custom tensioner and accidentally arrived at one that matched the original style nicely. This allows the use of a toothed pulley that I think makes for less transmission of belt artifacts into the skin layers.
Recommend print at least in PETG/ASA - though PLA is fine on a fairly stock setup.
The Pulley carriage should probably be printed on its side for strength with a little support for the small overhang.
The main body and knob can print vertically.
I added fuzzy skin coz I like the fuzz.
You'll need a GT2 toothed pulley with M3 hole. 16-18mm m3 bolt, and a M4x25 hex bolt with nut.
Also, a M4x30 if you want to anchor it in place through the existing hole in the 2020 profile.
