The Stagecoach modified embossed decals.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Makes all decal options able to be embossed for more consistency across the blaster.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 435
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
While planning the build for this masterpiece, I was unhappy with the inconsistency of the engraved vs embossed options.
While it's obvious why, Some parts need to be printed “face” down so the embossed was not an option.
I was not a fan of printing the face in gold and the rest in brown or vice versa, So I set out to find another way.
I also increased the height of all embossing to 1mm total, up from 0.4mm. It made the gold stand out a bit more against the brown I chose.
Divided priming-bar-engraved-center in half down the middle.
-Applied some glue but unsure if it was actually needed.
Made a cut on both priming-bar-guides-engraved left and right to split them each into two parts.
-1x extra screw on both sides for a total of 2. I'm using M3x8mm but made to use the same hole sizes.
-Made to used the same thread forming screws in the BOM and hardware kits, However I'm metric and didn't have any spare so in their place I'm using M3 x 8mm button heads and they work fine. I would recommend countersinks though.
Extruded all embossed decal plates an extra 0.6mm to a total of 1mm, Or 5 layers at 0.2mm layer height, To allow more “pop”.
-Looks pretty cool.