The Stagecoach modified embossed decals.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Makes all decal options able to be embossed for more consistency across the blaster.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 60
- Makes
- 0
- Views
- 435
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
While planning the build for this masterpiece, I was unhappy with the inconsistency of the engraved vs embossed options.
While it's obvious why, Some parts need to be printed “face” down so the embossed was not an option.
I was not a fan of printing the face in gold and the rest in brown or vice versa, So I set out to find another way.
I also increased the height of all embossing to 1mm total, up from 0.4mm. It made the gold stand out a bit more against the brown I chose.
Divided priming-bar-engraved-center in half down the middle.
-Applied some glue but unsure if it was actually needed.
Made a cut on both priming-bar-guides-engraved left and right to split them each into two parts.
-1x extra screw on both sides for a total of 2. I'm using M3x8mm but made to use the same hole sizes.
-Made to used the same thread forming screws in the BOM and hardware kits, However I'm metric and didn't have any spare so in their place I'm using M3 x 8mm button heads and they work fine. I would recommend countersinks though.
Extruded all embossed decal plates an extra 0.6mm to a total of 1mm, Or 5 layers at 0.2mm layer height, To allow more “pop”.
-Looks pretty cool.