CORE One Chamber Thermistor Protector - Remix, use original screws
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This remix allows you to use the original screws The snap-in-place variant doesn't even require unscrewing the screws.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 53
- Wydruki
- 7
- Wyświetlenia
- 251
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Update 2025-12-11:
Added a version that just snaps into place. No unscrewing of the screws needed and cannot come loose since it's locked by the screw heads.
I think the idea of a protector for the flimsy thermistor is brilliant, but unfortunately I only had one 35 mm M3 screw available, so I made a new version, very much based on the original, where the screw holes are on the back and the front holes are increased so that the heads fit.
Print it on the side, as in the screenshot, for cleanest print. Use PETG or ASA, or even PC-CF if you are fancy, and perhaps add a small brim, but should probably be fine without. Takes < 20 minutes @ 0.2 mm and uses very little filament.