1 / 2
608 Bearing with grease hole and less wiggle — zdjęcie 1
1 / 2

608 Bearing with grease hole and less wiggle

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bearing has grease hole for easy and fast reduction of friction. Modified inner ring for reduced radial wiggle.

Ocena
5 / 5
Polubienia
6
Pobrania
27
Wydruki
1
Wyświetlenia
117
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

About

Very simple 3d printed bearing with few improvements to similar bearings I have seen.

Improvements:

  • Smallest tolerance I could do with PLA on Prusa Core One (0.1mm between inner and outer ring)

  • Small bevel for easier mounting

  • Making greater outer diameter of inner ring for less radial wiggle

  • Adding hole for easy and fast way to apply grease 

Print Settings

Changes to Prusa Slicer from default “0.10mm FAST DETAIL” profile:

  • Set layer height to 0.1mm

  • First layer height to 0.1mm

  • Perimeters to 5 

Making seams to not expand is critical for small tolerances so also this changes has to be made:

  • Seam position to Random

  • Seam gap distance to 200%

  • Scarf joint placement to Everywhere

  • Scarf join length to 5mm

 

To see some of this settings you have to be in “Advanced Mode” in Prusa Slicer.

Assembly

This print to work requires good calibration to meet tight tolerances.
I advice to first print bearing with 0.2.mm tolerance, if it rotates without any problem then you can try printing 0.1mm tolerance version.

Bearing with 0.1mm tolerance won't rotate after print. You have to give it quite a few hits from each side for it to unlock. I hit it 10 times from one side with something quite heavy then 10 times another side, repeat this procedure one more time (total around 40 hits) and most of the time bearing is rotating.

After that for better operation I place 5mm screw inside bearing, screw it with bolt and rotate inner ring using a drill. Then I add grease.
 

Assembly TLDR for 0.1mm version

  • Hit bearing few times from each side

  • Rotate inner ring using a drill

  • Add grease
     

 

Tagi