Peblar EV charger cover with plug mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cover for the Peblar charger with a socket to hang the plug. This is only compatible with chargers with a fixed cable.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 60
- Wydruki
- 1
- Wyświetlenia
- 410
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
I recently got a new charger for my EV. The previous one had a socket in the charger itself where I could hang the plug when not plugged in to the EV. The new one is a Peblar charger and it comes with a fixed cable but nowhere to hang the plug when not charging. It has a rubber cap that fits in the plug to protect it from moisture and dust.
I always need two hand to get the cap on or off when I start or stop charging the car. This is annoying, especially because I was used to do it with one hand.
I didn't want to damage the original cover because the charger is not mine (yet). So I drew the complete lower cover and embedded a socket for the plug in it. The cover just clicks into place, just like the original one.
The plug also clicks into the socket, the socket has a small bump on the inside which snaps into the hole in the top of the plug.
I printed mine in the orientation it is mounted so all visible surfaces are clean and have no support marks. It was printed on a Bambu A1 and took a little over 7 hours.
When you print this, please share a photo :) and let me know if there are improvements to be made. I hope you enjoy this one!