Sovol SV07 PTFE bowden tube guide
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bowden tube guide to move material spool from top of the printer elsewhere
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 59
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v3.0
I do not want spool of material hanging on top of my printer but prefer it being set aside on separate holder or inside drybox. So I made simple bowden holder that will create secure place to hold PTFE tube for guiding filament from side of the printer to the filament sensor.
Basically any material should work for this as the part is not stressed by any heat from printer, I chose PET-G for its higher flexibility.
Before printing make sure you calibrated printed dimensions. If higher tolerances are needed, feel free to edit attached FreeCAD model to desired tolerances.
Aditional parts
- 4x M3x20 screws
- zip tie (optional - for securing PTFE in place)
Notes
- Yes, bottom bracket is very close to the bearing. However it does not limit its movement.
- zip tie is probably not needed as PTFE tube hole is modeled as 4,1mm which is enough for press fit
- If the hole seems to be a bit smaller, just use 4mm drill bit and enlarge it.