1 / 5
Remix of custom fan duct for Artillery X4 Series with light and runout sensor — zdjęcie 1
1 / 5

Remix of custom fan duct for Artillery X4 Series with light and runout sensor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Same as original, but added a bar for an led strip and a mount and housing for the runout sensor with a PTFE connector

Ocena
5 / 5
Polubienia
3
Pobrania
44
Wydruki
1
Wyświetlenia
308
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Since my spools are stored in dryboxes with PTFE tubing, I wanted to connect those directly to my printhead. To still utilize the runout sensor functionality, ich dug the original one out of its housing and planted the sensor PCB,  the magnet and the steel ball into a new housing that is attached to the model's original duct holding frame. For that I used m3 brass inserts. The sensor housing itself has m3 threads cut for the lid and an M6 thread in the plate for the PTFE connector.  I rerouted the wires of the sensor down and through the mesh tube together with the printhead cables. For that I needed to extend the original cable, so some soldering is required.

For lighting, I was not pleased with the Printhead led throwing a shadow in my direction. So I added a curved bar on the fan duct which centers and aims around and at the nozzle/fan duct center*.
I used a simple piece of a 24V led strip and soldered the cables to the 24V hotend fan connectors on the printhead board. For easier maintenance, I added a connector to the cables.
This way, without further modding I automatically have light as soon as the hotend is warm and it switches off when idle/cooled down.

*Also I did another Version since for visibility, I placed the leds as high as reasonable so the view on the nozzle from the front would remain free. But for illumination it would be beneficial to lower them a little, so I created another Version that is a compromise between field of view and direct light on the nozzle.

I'm not sure how doable this is for everyone, but I'm happy if this helps anyone else to have even more convenience/visibility. 

I printed this in ABS with 0.4mm nozzle and 0,16mm layer thickness.

Orientations were according to the original recommendations apart from the left arm, which did not work with my modifications, so  layed it flat on the outer surface.

Tagi