Buddy3D holder for EnXLosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple Buddy3D camera holder that fits on EnXLosure screws
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 49
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a simple holder for Buddy3d camera on an EnXLosure. It gives a lovely view angle that just covers the whole build plate. The camera is mounted outside the EnXLosure, so it's protected from heat, but you'll probably need to wipe the dust from the transparent sheet in front of it now and then. You can still open the top EnXLosure cover as usual.
Print as oriented with 0.20mm resolution and add supports under the two tabs of the circular camera mount only. Any material should work, it's mounted outside the EnXLosure and should not get too hot.
When printed, unscrew the center three screws on the front bottom cross-member of the EnXLosure. These are 8 mm long and you can probably reuse them, but if they don't grip well, swap them with 10 mm long ones. The mount is 2 mm thick, so that should be enough in any case.