Ender3 V3 SE Raspberry Pi zero 2w with camera mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of the model by @bioxz (also remixed). This model features a bigger camera slot to fit a bigger camera (Arducam)
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 283
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Update 01-21-2026:
New model uploaded. Old model could be bumped by hot end if it goes beyond X0 with auto level.
This is a remix of the original Pi Zero 2W + Pi Camera Y-axis mount, modified to support the Arducam Rev.C OV5647 CS (B0032).
The camera mount has been realigned so the larger CS-lens housing clears the nozzle and frame without collision, while keeping the same compact footprint and clean cable path as the original.
From what I can see, other Arducam models share the same board width/height, so this remix may be compatible with additional Arducam variants as well.
The mount still attaches to the Y-axis end using two M3×16 mm screws and does not interfere with any moving printer parts. It remains a neat way to run OctoPrint or Klipper directly on the printer using a Pi Zero 2W and attached camera.
Requirements
2 × M3 × 16 mm screws (replace the stock Ender screws)
Your preferred Pi Zero (2) case lid from the original design:
https://www.printables.com/model/267909-raspberry-pi-zero-zero-2-case-snapfit-screwless-inCamera (Arducam Rev.C OV5647 CS B0032)
Information about the camera:
- https://docs.arducam.com/Raspberry-Pi-Camera/Native-camera/5MP-OV5647/
- https://www.uctronics.com/ov5647-camera-board-w-cs-mount-lens-fully-compatible-with-raspberry-pi.html