ZSA Navigator Moonlander Shells
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A collection of ZSA Navigator shells to use with your Moonlander! Options for both the Trackball and Trackpad.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 848
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
A collection of ZSA Navigator shells to use with your Moonlander!
First, choose whether you want the thumb shell or the side shell, and what side you want it to be on. Get that STL, then grab the opposite-side wedge STL to make sure both halves of your board have the same tenting angle.
All pieces can be mounted to the back of the Moonlander with 4 M2.5x5 screws per side.
Moonlander Navigator Thumb Shell
This design puts the trackball underneath the thumb cluster, more in reach of your thumb. You can also use your palm, but this may be less precise.
Note that the default short TRRS cable that comes with the Navigator is slightly too short to reach the Navigator all the way down here from the Moonlander's TRRS port. So, the print instead accommodates a right-angle TRRS connector so you can use your default Moonlander TRRS cable. You could also use a longer third-party TRRS cable with a straight connector if you'd prefer.
Moonlander Navigator Side Shell
This design puts the trackball to the side, similar to the default Navigator mount for the Voyager. It also lowers the trackball relative to the tops of the keys (so they are about the same height), so shifting your hand from typing to mousing feels nice and natural.
If you have a Navigator Trackpad, there's a raised version of this shell that may be a little more comfortable since the Trackpad naturally sits lower.
Moonlander Navigator Platform Shell
This shell is a thinner version of the side shell meant to work with the Platform. It repurposes the tenting leg screw for extra stability. There is a specific order of operations for installing it:
Tighten your thumb cluster at your desired angle.
Remove the default side tenting leg. This design only uses that screw, so store the leg and the spring somewhere safe.
Lay the Platform mount on the back of the board, then position the shell mount over it. The shell mount has a small shorter area to accommodate the Platform arm. Screw in both mounts using the default Platform screws.
Screw the tenting leg screw back in using a hex wrench. There are cutouts in the shell to make this easier.
Plug in the Navigator cables.
There's also a raised version for the Navigator Trackpad.
Enjoy!
— Robin, ZSA