DJI Mavic Mini 5 Pro Handle / Grip / Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Based on a 3D scan of the drone I designed a lightweight, well fitting handle for the new Mavic Mini 5 pro.
- Ocena
- 0 / 5
- Polubienia
- 3
- Wydruki
- 0
- Wyświetlenia
- 635
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Standard Digital File License
attention: you need to disable the optical positioning and obstacle avoidance in settings -> security -> advanced. this is the only mode where you can 100% freely fly and catch the drone mid air, like on a boat.
Based on a body 3D scan I designed this lightweight handle (hope this is the right word for it) for the new DJI Mavic Mini 5 Pro.
This allows much saver mid air catching of the drone in difficult conditions where landing on a surface is not possible. I use this design on boats primarily where its difficult to hover above a hand to initiate the landing sequence.
2x m6 melt thread inserts are used and 2x m6 nylon screws.
For a good grip, some sticky foam tape is needed. I used a 1mm thick one at the top and bottom bracket (see pictures).
The whole grip device adds a little over 20g of weight - this can be easily handled by the mini 5 pro.