1 / 4
DREMEL 4000 stand (carpenter's clamp, M4 screw, beefed up) — zdjęcie 1
1 / 4

DREMEL 4000 stand (carpenter's clamp, M4 screw, beefed up)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of a Remix. I just beefed up the clamp so it's less prone to breaking and exchanged the M3 for M4

Ocena
0 / 5
Polubienia
24
Pobrania
90
Wydruki
0
Wyświetlenia
367
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Printing

For stability use the following settings:

  • PCTG or PETG

  • for 0.8mm nozzle:

    • 4 walls/perimeters

    • 25% honeycomb infill

  • for 0.4mm nozzle:

    • 8 walls/perimeters

    • 35% honeycomb infill

In the .3mf I actually cut the model into two parts and used honeycomb infill on the lower part for the clamps and 3D honeycomb on the upper part for the clamps

Usage

  • Use a M4 nut (or alternative)

  • Use a M4 20mm to 25mm screw (or alternative)

  • Clamp to table using two carpenter's clamps or screw to table using the four mounting holes

If you don't want to bother looking for M4 screw, you can try this fully printed Alternative

Making

The very first original was made in Blender and can be found here: https://www.thingiverse.com/thing:1259799

I then beefed up the clamp in blender and re-imported into FreeCA where I made the M4 hole and nut cutout.

Tagi