1 / 8
IKEA UTDRAG reusable extractor hood filter — zdjęcie 1
1 / 8

IKEA UTDRAG reusable extractor hood filter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a a replacement for the overpriced single use filter for Ikea UTDGRAG extractor hood.

Ocena
0 / 5
Polubienia
2
Pobrania
11
Wydruki
0
Wyświetlenia
90
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Public Domain

This is a simple replacement for the overpriced single use filters for Ikea UTDRAG extractor hood. It uses standard filter sheet that are available in pretty much any store (Amazon sells them for 10€).

This is very easy to use. Simply cut the filter to size (about 125 to 130 mm wide), cut the corners (don't need to make it perfectly round), make a 30 to 35 mm wide slit in the middle, then stuff the filter in the top part, inserting the center pillar into the slit. Remove the used filters from the hood, then attach the replacement one by  stacking the top on the bottom part. The whole assembly is held by the center pillar.

Print the two parts facing down, simply enabling supports against the bed only. It printed flawlessly in a about 2.5 hours for the two parts on my Bambu A1 Mini. Keep in mind that you will need to print each part twice in order to replace the two filters.

I used PLA with good results so far, but PETG might be a better choice for durability, considering that the part could be exposed to some heat. (Not too much, hopefully)

Tagi