EFlite 1.5m At-6 Texan Exhaust
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A little addition to help your plane look more realistic.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 382
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I am doing a Canadian livery on my Eflite AT-6 and wanted an exhaust pipe to help it look more scale like so I designed this.
Printed @ 20% infill with supports “ touching build plate only”. Print it laying down as shown in the pics. Although not necessary once done you might want to spend a few minutes cleaning it up and then painting it flat black. Mine has not been finished yet but it will be before the plane is done. I used Foam-Tac to attach it to the pipe coming out of the fuse as well as cut a little slot for the attached support and used the same glue for that. After it was completed it added 18 grams to the plane. That's less than an ounce.
EDIT: Cowling and dummy radial can be found here…
https://www.prusaprinters.org/prints/83896-eflite-15m-at-6-texan-cowl-and-radial