Universal Projector Legs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I recent bought a JIFAR projector (link) and felt as though the single kick stand leg wasn't enough to properly level…
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 119
- Wydruki
- 2
- Wyświetlenia
- 1440
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I recent bought a JIFAR projector (link) and felt as though the single kick stand leg wasn't enough to properly level and raise the projector. I created these universe legs and mounts to work for my projector, but they should work for any other projector who mount screws are within 9.5mm to 45mm of the edge of the projector (The legs would work on my BENQ MH530FHD, if I actually had a need for them.). The mounting hole is 4mm wide, to easily take a m4 screw.
Uniscrew-46mm.stl - 46mm tall leg seen fully extended in image 6.
Uniscrew-46mm.stl - 31mm tall leg seen fully extended in image 5.
Unimount.stl - The mounting slot if from 9.5mm to 45mm from the edge of the projector.
Unimount-smaller-mount-hole.stl - The mounting slot if from 27.5mm to 45mm from the edge of the projector.
This work is a remix of 3DWorkhorse work, which is a remix of Daviepadilla work.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.3mm
Infill:
25
Post-Printing
The fit is going to be tight, a little Super Lube or olive oil should make the parts screw together without issue. I use an m4*6 screw to mount the mounts for the legs to my projector.
Category: Electronics