SAEGEWERK Redux

Geist's KLOR SAEGEWERK BLE, modded and built to fit my needs, it features no haptics nor buzzers, no displays, reset buttons were skipped; furthermore during the build:

• the PH2.0 battery connectors and the MCUs were installed on the top side of the PCBs (components facing down, in the outlined set of headers)

• used medium height headers under which the run of the mill 301230 LiPos fit (pay attention to the polarity of your battery connectors: if they're matching the silkscreen, bridge the jumpers next to the JST headers; if they are flipped, instead of de-pinning the LiPos you can bridge the jumpers on the opposite side of the PCB. double check the connections with a multimeter to make sure)

• alternate cover for builds that have encoders installed

All models can be printed without supports, orientation of the parts on the print bed should be self explanatory. .step files are available for easier modding. Hardware required for the assembly of both halves listed below.

BOM:

• 14x M2x3.2mm OD 3-4mm L heatset inserts / aliexpress

• 10x M2x12mm hex screws* / aliexpres 

• 4x M2x6mm hex screws* / aliexpress

• 8x 10x2mm bumpons / aliexpress

*alternatively, instead of buying two types of screws, M2x12mm can be used instead of the M2x6mm, with the caveat that you might get sick of screwing them in.