Attic Hatch air seal clamps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 3-piece manual latch that can be used to hold a flat plywood attic hatch down tightly, creating an air seal.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 82
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
When re-doing and enlarging my attic hatch, I wanted a way to hold the relatively light hatch panel (1/2" plywood with 6" of rigid insulation foam on top) down tightly against the hatch opening/trim it sits on, as to create an airtight seal.
So, I put some weather stripping around the border of the hatch, then designed these clamps to hold it shut tight to hopefully make my leaky house a tiny bit less leaky.
All PLA. For the make and female arts:
5 perimeter layers
30% gyroid infill
For the washers:
10 perimeter layers
50% gyroid infill
I had the make the washers stronger, because the first test started to bend/deflect a bit too much when I tightened it down a little bit.