RC car shock absorber fully printed #4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Improved version with a visible TPU spring. It is compatible with my Unimog / RCCAR V2 designs (use retrofit adapters)
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 168
- Wydruki
- 2
- Wyświetlenia
- 821
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial
The former spring was quite fragile because of the print orientation; it would separate in 2 or 3 parts after a while.
This design is basically two small springs similar to my PLA/PETG springs like in this design connected together so they can slide along the piston (you can ease that by putting some lubricant)
Because this time the TPU spring is printed in the other direction, the flexing happens along the perimeters and not along the layers.
To print TPU, to protect your build plate I suggest using masking tape.