GLEDOPTO ESP32 Wled Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
This is a simple 3D printed box designed for a GLEDOPTO ESP32 WLED controller.
The enclosure is a 2-part design (base + lid):
Screw-on lid using 4 corner screws for easy access and a secure close (M2 screws).
Push button mount (included): the push button is glued in place and supported by a printed brace (brace model included) to keep it solid and aligned.
The controller is held in place using printed pins (pin model included). I glued the pins in place after fitting them to keep everything locked down.
Cable pass-through holes:
5.0 mm diameter (output)
3.5 mm diameter (input)
Print the box open-side up and the lid flat, no supports needed.
Non 3D printed parts:
4x M2 screws
Pushbutton and button-cap from this set.