Flywheel, 168mm for goBilda hubs (16mm Square x M4 mounts, 6mm D-shaft, 8mm or 12mm Hex Shaft Fly Wheel)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A compact flywheel for energy retention in robotic ball throwers and other projects.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 151
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
REVISED: goBilda hubs fit properly now without modification. Please re-download and delete earlier copies.
A compact set of flywheels made with Robotics in mind, but useful wherever the storage of rotational momentum is needed. Either of these two parts can be used stand-alone, or they can be combined as in the drawing to make up to a very large flywheel. Requires either a 12mm hex shaft or a mounting hub such as goBilda's hubs.
You and you alone are responsible for determining what use cases are safe for your 3D prints. For safety, do not use from questionable or low quality prints. If you can't print these cleanly, don't use them. And in any case, don't operate these faster than is safe given your material choices and your printed copy.
For best results, print with 4 walls, 5 top and 5 bottom layers. And, as much infill as you can cleanly produce... The theoretical ideal of 100% can be extremely difficult to successfully print, because any over-extrusion calibration error has nowhere to go. And even without that error, the cooling properties of a solid mass are very different from even 80% infill, and typically cause issues with prints.
Slowing your print speed significantly is recommended if printing at 90% or more infill.
PLA and PETG have some of the highest material densities, so are good choices for parts like this where density is useful. At 80% infill, you can expect for each 1/2 main wheel to be around 310g and about 180 to 200g per additional disk.
BOM:
Filament:
PLA+: https://amzn.to/3MjaRpN
PETG: https://amzn.to/4a0Bqd3
SUPPORTING YOUR FAVORITE DESIGNERS:
Please like, download, follow and/or use the affiliate links below to support my work and encourage more of it.