Cr10S-Pro to Switchwire Conversion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The following are a set of modified Voron Switchwire stl files to allow a Cr10S-Pro to a Switchwire (minus the y-axis)
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 282
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Full video guide for the conversion can be found here:
This conversion only includes the x and z axis, not the y axis. Files needed to convert the y-axis can be found here: https://github.com/tripscavern/CR10SPro2Switchwire/tree/main/stl/originals and video instructions can be found here:
and here:
All of the parts need to be printed only once accept for [a]_upper_idler_support_b, which must be printed twice.
A guide for installing the new touchscreen can be found here:
Differences in BOM from the normal SW:
You can reuse the following form the Cr10s-Pro
All Frame Aluminum Extrusions
Fasteners used in
Rubber Feet
the y-axis Limit Micro Switch
Bed leveling probe (depends on what version of the printer you have)
All 3 NEMA17 Motors
The PSU/relay
Power Cables
The power socket/power cord
Internal Cooling Fans
Build Plate/Y Carrier
PTFE Tube
A number of M3/M5 fasteners
As a result, you can subtract the following from the official Voron Switchwire self sourcing guide:
Rubber Compressor Foot
1 of the 2 Omron Mouse Button - Micro Switch's (the one for the x-axis is still a requirement
BAT85 Diode
All 3 NEMA17 Motor 17HS15-1504S1
Mean Well LRS-350-24 PSU and Mean Well RS-25-5 PSU
ZF - Rocker Switches DPST 16A ON-OFF
Fuse Medium Time Delay Acting 8A 250V Holder Cartridge 5 X 20mm Glass
TycoElectronics - 10EGG1-2 (Normal) or 10EHG1-2 (Medical): Filtered Power Inlet
IEC320 C14 Inlet - Push-fit - w/ Rocker Switch & Fuse
40x40x10 Axial Fan- Ball Bearing (24V)
At least 1 USB Cable A-male Mini B-male
MOSFET Trigger Switch Drive Module
All frame components
Bowden Tube
All Fork Spade Terminal's (unless you decide to power the raspberry pi with the printer's power supply, in which case you will need 2)
All Insulated Crimp Recepticals
Prusa MK52 Heated Bed - 24V
Spring Steel Sheet for Prusa MK52 Bed
Prusa MK3 Y Carrier
Some components, specifically fasteners, cables, and connectors can be self sourced at lower quantities (use the Voron assembly manual as a guide): https://vorondesign.com/voron_switchwire
The Original Cr10s-Pro hotend/extruder motor could also be reused depending on the hotend/extruder setup you plan on going with