Anti-Glare Shield for Xiaomi Light Bar

Are you tired of direct LED light shining in your eyes from your monitor light bar as well?

This project solves that problem. This shield slides onto your light bar from either side, blocking direct line-of-sight to the LEDs without affecting the desk illumination. The parts are designed to be rotatable, allowing you to adjust the shielding angle to your exact preference.

Files included
Left and Right.
Clamp to join those together. I used a few tiny drops of cyanacrylate glue to join them together.

Recommended Print Settings:
Material: PETG is highly recommended due to the heat generated by the light bar. PLA may warp over time.
Nozzle: 0.2 mm (recommended)- 0.4 mm should also be fine.
Layer Height: 0.1 mm. [0.2 mm for a 0.4 mm nozzle should be fine].
Orientation: Print standing upright (see attached screenshots).
Adhesion: Use a brim and glue stick/adhesive on a smooth sheet. Because the parts are tall and thin, bed adhesion is critical.
Tolerance: For a perfect fit, be sure to compensate the shrinkage of your material (see Teaching Tech's video "Calibrating for Shrinkage is a 3D printer process most ignore" on YouTube).

For my PETG the shrinkage is 0.42 %.
-> For PrusaSlicer: Shrink compensation XY: 0.42 %
-> For Orca Slicer and Bambu Studio: Shrinkage: 99.58 %
(see the Teaching Tech Video where to find those settings)

Important Note on Nozzle Size
This model's joints are optimized for a 0.2 mm nozzle. The main parts will print fine with 0.4 nozzle. If you attempt to print this with a standard 0.4 mm nozzle, the joints may fuse together or require manual tolerance adjustments in your slicer.

Assembly
Slide the left and right parts onto the light bar.
If you prefer a permanent fit, you can glue the two halves together at the join, but it is not strictly necessary.
For glueing it is recommended to rotate the shield for not getting glue on the light bar itself.

Rotate the assembly to block the light as needed.

Have fun and save your eyes!