Onewheel Pint/GT - Trunk Stand

Update: 7/25/2024

• Added GT/S variant
• Added M3 nut cut-outs to skid plates

__________________________________________________________________________________________________________________

This design was inspired by the original remix from Asuswild.

• It can accommodate boards fitted with any/all of the following: the official Maghandle, rail guards, and fender.
• When properly positioned, only the tire's sidewall touches the holder.

My take on the design provides multiple benefits.

• The hollow center dramatically reduces print time and material consumption
• The rounded edges allow for smoother drop-in of the board
• The interlocking design provides support for smaller print-beds
• The cleated bottom skid plate almost entirely prevents movement in carpeted trunks
• Replaceable bottom skid plates leave room for different grip designs and color combinations

__________________________________________________________________________________________________________________

Compatibility

• Pint/Pint X
• GT/GT-S

Assembly

• (6x) M3x20mm bolts (required)
• (6x) M3 washers (optional)
• (6x) M3 nuts (optional, the threads self-tap into the skid plate)

1. Print 2x of the holder and skid plate
2. Snap together the top and bottom sections separately
3. Line up the holes and screw the two sections together (the skid plates will be rotated 90° relative to the holders)