ESR HaloLock adapter for VW T6.1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter for ESR magsafe charger to fit into the compartment next to the shifter.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Rock-solid adapter for ESR magsafe charger ("ESR HaloLock CryoBoost") to fit into the compartment next to the shifter (see photo). The car is a 2023 T6.1 baseline transporter with automatic. The compartment remains accessible for storage. The phone is placed in a convenient orientation/position where it is accessible to both the passenger and driver, and very unlikely to be bumped off even if you move around in the car. You can route/hide the USB cable through the holder. There is a minimal version and a "Molle" version that allows adding a small pouch for cables, adapters etc. (shown in foto).
Requires 4 M2x6 or M2x8 screws. Do not overtorque!
Print with the open side down and supports on the build plate. Block supports in the big horizontal channel, they are not necessary. When using warp-prone material, add 8 mm brim with zero contact distance both inside and outside. Any cut marks from removing the brim will not be visible once assembled. I added a few rubber pads to the inside of the clamp. They are not necessary for function, but remove otherwise unavoidable rattle noises (plastic on plastic...).