1 / 5
Fiat 600 gauge pod to replace the ash tray — zdjęcie 1
1 / 5

Fiat 600 gauge pod to replace the ash tray

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fits a standard 2" or 52mm gauge and clips into the dashboard where the ash tray would go.

Ocena
0 / 5
Polubienia
4
Pobrania
18
Wydruki
0
Wyświetlenia
113
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Fits a standard 2" or 52mm gauge and clips into the dashboard where the ash tray would go. I print the gauge holder with the circle side down with supports. I print with a 40mm/s outer wall and 25% infill, but it's not necessary.

First, attach the gauge to the lid. Next, clip the gauge holder into the hole in the dash. Run the wires through the hole and holder and attach to the gauge. Finally, use a small bit of glue to attach the lid to the holder while paying attention to the rotation of the gauge. Done!

Note: You'll find it easiest to attach the wire leads to the gauge before you install it.

Tagi