1 / 5
Fiat 600 gauge pod to replace the ash tray — image 1
1 / 5

Fiat 600 gauge pod to replace the ash tray

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fits a standard 2" or 52mm gauge and clips into the dashboard where the ash tray would go.

Rating
0 / 5
Likes
4
Downloads
18
Makes
0
Views
113
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial — Share Alike

Fits a standard 2" or 52mm gauge and clips into the dashboard where the ash tray would go. I print the gauge holder with the circle side down with supports. I print with a 40mm/s outer wall and 25% infill, but it's not necessary.

First, attach the gauge to the lid. Next, clip the gauge holder into the hole in the dash. Run the wires through the hole and holder and attach to the gauge. Finally, use a small bit of glue to attach the lid to the holder while paying attention to the rotation of the gauge. Done!

Note: You'll find it easiest to attach the wire leads to the gauge before you install it.

Tags