1 / 2
QUBE 500 front 120mm fan duct / shroud — zdjęcie 1
1 / 2

QUBE 500 front 120mm fan duct / shroud

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Basic 120mm shroud for front intake/exaust

Ocena
0 / 5
Polubienia
2
Pobrania
7
Wydruki
0
Wyświetlenia
167
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a front exhaust / intake shroud designed specifically for the Cooler Master QUBE 500.
My first print (with supports and before I realized a cutout was needed) used approximately 200 g of ABS.

The final print shown may look rough because I had just moved and printed it in ABS without an enclosure, which required some creative plastic welding to finish the part.


Observations

for some reason this model started interfering with the side glass after a few months, i do not recomend printing if you dont want to deal with this (sanding and/or some spacers to angle it a little)

I designed this model specifically for my setup. Since my PC is placed under a desk in a very hot country, I needed additional front exhaust to prevent hot air from accumulating underneath the desk. To solve this, I created a simple shroud to redirect hot air from my Peerless Assassin air cooler toward the front of the case.

I will soon provide the under desk support I designed.

This model requires supports in specific areas and is designed to be mounted using either zip ties or standard fan screws.

The cutout in the duct is for the PSU bracket and only works when the bracket is installed in the top position. The holes used to attach the duct to the front panel are correctly aligned for my case. The two “lonely” holes should line up on most PCs, but the three grouped holes may not (there are three to improve the odds).
I recommend printing the section with the three screw holes at 100% infill, so you can drill a custom mounting hole if none of them align.


Printing Settings

  • This model requires supports in two areas: the two “lonely” holes.

  • Printing the section with the three holes at 100% infill is recommended, in case you need to drill a new mounting hole.

  • The model is already oriented in the recommended printing position.

  • There is a very small section near the top that technically needs support, but on most printers it can be printed without it. Minor cleanup may be required afterward.

  • Material: ABS or PETG

    • Do not use PLA, as the temperatures measured in my setup are high enough to soften it, and this part is structural (it supports the fan).

  • Warping must be managed carefully, as the part is large and contains long, straight sections.


Limitations

There may be additional limitations, but these are the ones identified so far:

  • The PSU bracket must be installed in the top position. Any other position will require an offset or a larger cutout in the shroud.

  • My PSU is approximately 85 mm tall. Taller PSUs may not fit. Clearance from the back of the front panel is roughly 100 mm. (psu height+psu distance from back of front pannel)

  • This works with my Peerless Assassin cooler, but I do not use a fan above the RAM. My setup includes one fan in the middle and one at the rear of the tower.

  • I use an Arctic P12 Pro running at 1200 RPM, which moves a reasonable amount of air.

  • Fans with lower static pressure, or systems using dust filters on the front panel, may experience reduced performance.

Tagi