Triangular Furniture feet screw mount V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A new version of feet for my dogs' feet board with more robust layer orientation.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 157
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The layer orientation in version 1 is not suited for use cases where someone's doge jumps on it from angles that are not 90° in the Z direction.
That led to critical shear stresses in the construction!
Version 2 can be printed in a much more optimal orientation for such everyday loads and therefore is split into 2 parts to extend the failure safety even more while using less material than Version 1.
Depending on the weight of the thing you want to put on top, I would
Increase perimeters and infill. I printed mine from Extrudr Green Tec Pro just in case my dog wants to jump into a shear stress test again.
Use 4mm screws for mounting the same hole pattern as in Version 1😉