Triangular Furniture feet screw mount V2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A new version of feet for my dogs' feet board with more robust layer orientation.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 25
- Makes
- 0
- Views
- 156
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The layer orientation in version 1 is not suited for use cases where someone's doge jumps on it from angles that are not 90° in the Z direction.
That led to critical shear stresses in the construction!
Version 2 can be printed in a much more optimal orientation for such everyday loads and therefore is split into 2 parts to extend the failure safety even more while using less material than Version 1.
Depending on the weight of the thing you want to put on top, I would
Increase perimeters and infill. I printed mine from Extrudr Green Tec Pro just in case my dog wants to jump into a shear stress test again.
Use 4mm screws for mounting the same hole pattern as in Version 1😉