Wraith 3" FPV Frame — TPU Bits

TPU parts for the Wraith 3" FPV frame. Everything clips on — no screws, no zip ties (unless you want them). All parts designed for the 4mm bottom plate.

CAMERA CANOPIES
Slide down into the standoffs and lock in place once the top plate goes on.

HDZero: Lux 25° standard
Lux 25° 8mm standoff (slammed builds).
DJI Air: Flywoo O4 Air Unit (standard / chin / ND / chin + ND) / DJI O4 Air Unit 25°.
DJI Pro: DJI O4 Unit (standard / chin) 25°.
Foxeer Toothless 2 25deg
Foxeer Nano Predator 25deg

CONVERTED
Baby Ratel 30° / Foxeer Toothless 2 30° — both converted from a compatible clip-on system, instructions PDF included.
Canopy adapter (cam bottom extended) included for converting clip-on canopies to fit the Wraith.

ARM PROTECTION — Boots slip over the outside of the arm tips for crash protection around the motor mounts — v3 is the latest and the easiest to install, v2 if you still want a full protection. Just make sure what ever length screw you use adds an extra 1.5mm to clear the tpu.

Claws are aggressive arm tip covers with more grip and a wider contact patch (v2 current).
Sock Claw slips inside the arm tip, keyed to the frame so it stays put through crashes (v2 current). Legacy combo variants also included.

BUTT PLUGS (rear connector + antenna holders
XT30 and BT3 versions, both hold your connector and antenna.

OTHER
TPU nut for soft-mounting the stack.

3MF files include print settings for PrusaSlicer / BambuStudio. STLs provided for other slicers.

————————————————

PRINT SETTINGS (for the Printables settings fields)

Material: TPU 95A
Nozzle: 0.4mm
Layer height: 0.2mm
Infill: 100% for boots/arm protection, 15-20% for canopies
Supports: None