1 / 5
Sim Rig Headphone Holder – 8020 / Aluminum Profile Mount — zdjęcie 1
1 / 5

Sim Rig Headphone Holder – 8020 / Aluminum Profile Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple, sturdy headphone holder that mounts directly to your aluminum profile sim rig.

Ocena
0 / 5
Polubienia
5
Pobrania
43
Wydruki
0
Wyświetlenia
258
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

🧾 Required Hardware (not included)

You’ll need:

  • 1× M8 screw (length depends on your profile, ~16–20 mm works for most rigs)

  • 1× M8 T-nut for your aluminum profile slot

Everything else is 3D printed in a single piece.


🧩 How to use

  1. Print the stand (see settings below).

  2. Slide the M8 T-nut into the slot of your rig’s aluminum profile.

  3. Line up the hole in the stand with the T-nut.

  4. Insert the M8 screw through the stand and thread it into the T-nut.

  5. Tighten until the stand is snug and doesn’t move.

  6. Hang your headphones on the hook.

Works great on most 40-series and similar profile sim rigs.


🖨 Print settings (recommendation)

  • Material: PLA or PETG

  • Layer height: 0.2–0.28 mm

  • Perimeters/walls: 3+

  • Infill: 25–35% (for strength at the mounting point and hook)

  • Supports: Only if your slicer shows issues under the hook curve (often not needed)