1 / 4
Prusa XL Filament Roller, SUMO Enclosure Remix, profiled roller and captive bearing Remix — zdjęcie 1
1 / 4

Prusa XL Filament Roller, SUMO Enclosure Remix, profiled roller and captive bearing Remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A remix from bomtarnes --> Smorbickles --> e645824. I added a profiled roller and captive bearings.

Ocena
0 / 5
Polubienia
2
Pobrania
13
Wydruki
0
Wyświetlenia
95
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This remix builds on Smorbickles' spool holder.   bomtarnes --> Smorbickles --> e645824

Although that spool holder was specifically for SUMO enclosures, I remixed it as follows:

  • profiled the roller so that the spool doesn't wander around.  Should work with 1 kg (6cm) and larger (10cm) spools.

  • Added captive brackets so that the bearings don't pop out.

  • All printing is done vertically for a smooth profile.  No supports are needed.

  • The screw channel is shortened.  This allows for common-length screws.  Allows for either M4 and M5 screws.

When printing the roller, definitely use a glue stick since I specifically did not use a brim.  The 3 small pegs seem OK without a glue stick, but might as well use a glue stick for them anyway.

Everything is press-fit together.  I have a Prusa XL 0.4mm and used Hatchbox PETG.  The 3 pegs are sized 98% of the holes.  YMMV if you have a different printer or use different filament.  The pegs are separate items in the *.3mf file so can be easily resized independent of the other components. 

After printing, press-fit the pegs into the holes; no adhesive is needed.  The pointy peg goes into the roller, the other two pegs go into the main body and hold together:  main body, bearing bracket, and end-cap.  Install the roller with both bearings before putting on the end-cap.

My OpenSCAD file is attached.  Likewise, my 6 STL files are also attached.