Vinyl Record Wall Holder – Minimalist 31cm Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalist and sturdy wall-mounted holder for vinyl records. Suitable for records with or without sleeves.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 202
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
Description
This wall-mounted vinyl record holder is designed for a clean, minimalist appearance while providing reliable support for vinyl records. The holder is 31 cm (perfect for the Anycubic Kobra S1) wide and features a continuous bottom section that connects the back plate and the front lip, significantly increasing rigidity and overall strength compared to designs with separated supports.
Rounded outer edges give the model a smooth, finished look and help reduce stress points. The holder can be used to display a single vinyl record or a record with its sleeve, depending on the mounting height and spacing.
The mounting holes are positioned close to the outer edges for easy installation and good load distribution. Counterbored holes allow the screw heads to sit flush against the back plate, resulting in a neat and unobtrusive wall mount.
Mounting hardware
Recommended screws: M5 or M6 wood screws
Recommended length: 30–40 mm (depending on wall material)
Suitable for use with wall plugs / anchors if mounting to masonry or drywall
Screw heads fit into the integrated counterbores for a flush finish
Printing
The model is intended for FDM 3D printing and does not require supports when printed with the back plate flat on the build plate. It is suitable for common materials such as PLA or PETG.