Self Tapper Voron V0.2 Electronics Mount & Cable Guide (Raspberry Pi or BTT Pi, SKR Pico)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Customizable Mounting for Raspberry or BTT Pi and SKR Pico, plus Wire Management for electronics bay of Voron 0.2
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 279
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This was made in Tinkercad as i do not know how to use f360 but it is a good model besides that.
-- Original Models Description --
This 3d printable frame mounts in the electronics bay of the Voron V0.2 using the six screws that hold the panel that separates the electronics bay from the print volume (use 2mm longer screws). NO VHB TAPE is used. It provides mounting points for a Standard size Raspberry or BTT Pi (see file versions) and the SKR Pico Controller and provides a covered wireway running up through the middle of the bay with wire access slots and open ends for routing. Eight 2.5mm heatsets and screws are used for the Pi and controller mounting. The lid of the wireway is attached with two sets of 3mm hardware into Voron standard type brass heatsets. Best to print with PETG, ABS or similar for heat resistance. Adhesion with PETG is excellent (red example), for ABS (green example) I used a brim and enclosed chamber as is normal for ABS. No supports are required.
Note - The BTT Pi 1.2 has slightly different hole placement, the version added and tested by Petr. Thanks Petr. The earlier BTT Pi may have the same hole layout, I have not verified that. Make sure to use the appropriate file for your Pi type. The original was tested with Pi 4's and the Pi's have a very standardized hole pattern, at least for a standard sized Pi, and many other boards that copy that pattern will fit as well.