H1+ Muzi.Works Horizantal Charging Stand / Holder v2.2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Horizontal charging stand for the H1+ Heltec case that can fit a 3k mha battery. Fit might be to snug.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 71
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Stand works with the H1+ case and is meant for Horizontal storage and charging.
I would recommend printing with support for 65 degree plus. This helps support the rounded underside. Standard Infill and walls.
V2.2 might be a little to snug a fit. V2.1 may be a better option if you like a looser fit.
I created this to hold my Meshtastic node on my desk at work so it could be read normally.
Cable pass-through holes on the bottom of the holder are a little small. Should work if you have a skinny cable.