Parallel Marking Gauge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the “Mark II” version of the Parallel Marking Gauge
- Ocena
- 5 / 5
- Polubienia
- 411
- Pobrania
- 1380
- Wydruki
- 6
- Wyświetlenia
- 4675
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — NoDerivatives
This is the “Mark II” version of the Parallel Marking Gauge (or also scriber / ruler / t-square). It does exactly what it says - in increments of 1 mm (or 1/16th inch) - but this version comes with a flattened stop-block and markings on the back. This allows you to turn it around, place it against corners and draw parallel markings using the same holes.
It is a somewhat demanding print and for best results it is highly recommended to use the provided print profiles on a clean build plate. There are 2 colour changes to highlight the markings, either done manually (pauses are set in profiles) or with an AMS.
Print Settings:
0.4 mm Nozzle
0.2 mm Layer Height (also 1st layer)
0.4 mm Line Width
Wall Generator: Classic
Seam Position: Random
Only one Wall on First Layer
No Narrow Infill Detection
for the 25cm and 10 inch Version (diagonal): Infill direction 0°