Parallel Marking Gauge
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is the “Mark II” version of the Parallel Marking Gauge
- Rating
- 5 / 5
- Likes
- 411
- Downloads
- 1,380
- Makes
- 6
- Views
- 4,675
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — NoDerivatives
This is the “Mark II” version of the Parallel Marking Gauge (or also scriber / ruler / t-square). It does exactly what it says - in increments of 1 mm (or 1/16th inch) - but this version comes with a flattened stop-block and markings on the back. This allows you to turn it around, place it against corners and draw parallel markings using the same holes.
It is a somewhat demanding print and for best results it is highly recommended to use the provided print profiles on a clean build plate. There are 2 colour changes to highlight the markings, either done manually (pauses are set in profiles) or with an AMS.
Print Settings:
0.4 mm Nozzle
0.2 mm Layer Height (also 1st layer)
0.4 mm Line Width
Wall Generator: Classic
Seam Position: Random
Only one Wall on First Layer
No Narrow Infill Detection
for the 25cm and 10 inch Version (diagonal): Infill direction 0°