PTFE tube feedthrough bulkhead fitting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
bulkhead fitting for a "10mm" pass through PTFE fitting
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 126
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed this for drybox use. it is a feedthrough that allows a 45 degree outlet.
Threads for the "10mm" PC4-10M are NOT 10mm standard. (in fact they are BSPT 1/8in, tapered). the threads in this design are 10mm, .91 pitch non-tapered - a close approximation which works well.
printed here in PET-G, 6 perimeters, 20% infill for rigidity, no support.
Print thread side down for best thread result.
Assembly amounts to Drilling holes and clearing an appropriate area for the PTFE tube (I used the exit angle plate as a template) use 4, M3-8 hex cap head screws screwed directly into the exit angle plate.
The result is a rigid and air tight seal.
A wrench and a drill guide for the fitting install are also included