Ford Fiesta MK6 Antenna
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My Ford Fiesta's antenna went missing, and only the spring part that made the antenna flexible remained. I unscrewed…
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 128
- Wydruki
- 1
- Wyświetlenia
- 999
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
My Ford Fiesta's antenna went missing, and only the spring part that made the antenna flexible remained.
I unscrewed the spring, removed the rubber coating and made a model based on that.
Note: The antenna will no longer be flexible, but at least wont look as bad.
Note2: the inside diameter of the tip is equal or a bit smaller then the antenna to facilitate a mechanical fit(no glue required). To make the insertion easier just heat the tip of the metal antenna and press it all the way. It should melt and adhere to end/tip of the antenna.
Print Settings
Printer Brand:
Anet
Printer:
A4
Rafts:
No
Supports:
No
Resolution:
0.15
Infill:
100
Filament: Generic PLA PLA Black
Notes:
PLA is not suited for outside use.
In my case I don't care, if it will fail I will just print another.
Heat the end of the spring/antenna metal part, so when inserted, it will melt and adhere to the end of the cover.
Category: Automotive