CheeseMix NATO Rail with safety pins (2 to 10 holes long)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3d Printable NATO rail for camera rigging.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 150
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
3d printable NATO rail for camera rigging. Mounting holes are 18mm apart, compatible with CheeseMix plates and accessories. This pack includes rails from 2 holes long to 10 holes long. Each rail has a sprung pin on each end to keep hardware from sliding off incase something comes loose. I made the springs by straightening a pen spring and bending it into a U shape.

Printing | |
|---|---|
Layer Height | 0.2mm |
Walls | 3 or more |
Top/Bottom | 3 or more |
Infill | 25% or more |
Support | No |
CheeseMix is designed for 1/4-20 hardware. The main fastener is a 0.5" (1/2) long cap screw with a head Diameter of 0.375 (3/8) and a head thickness of 0.125" (1/8). The bolt head sits bellow the surface of the plate, recessed in the hex pockets. Nuts should be 7/16 flat to flat and 0.1875" (3/16) thick, or less, to sit bellow the surface of the plate.