Ice Maker Auger Drive Gear – Replacement Part (3D Model)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Motor gear for Ice maker with Auger motor model SEAA260A01.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 60
- Wydruki
- 1
- Wyświetlenia
- 228
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This model is a replacement auger drive gear used in refrigerator ice dispenser assemblies. The gear transfers torque from the auger motor to the ice auger, enabling ice to be conveyed from the ice bin to the dispenser chute.
The original part commonly fails due to plastic fatigue, cracking around the hub, or stripped internal drive features, especially under repeated load or ice jams. This replacement model restores functionality without requiring full auger or motor replacement.
Key Features
Designed to interface with a square-shaft auger drive
Straight-cut gear profile matching OEM geometry
Reinforced hub area to reduce cracking and premature failure
Suitable for left-hand ice maker auger assemblies
Optimized for 3D printing with minimal support requirements
Common Symptoms of Failure
Ice maker motor runs but auger does not turn
Clicking or grinding noise from dispenser
Cracked or split gear hub
Ice not dispensing despite motor operation
Printing Recommendations
Material: PETG, Nylon, or ABS (PLA not recommended due to brittleness)
Infill: 50–100% (higher infill recommended for durability)
Layer height: 0.2 mm or finer
Orientation: Flat face down for concentric strength
Post-processing: Light deburring of teeth and hub recommended
Notes
This is a non-OEM replacement design
Verify dimensions against your original gear before installation
Intended for repair and personal use
