1 / 1
Ice Maker Auger Drive Gear – Replacement Part (3D Model) — image 1

Ice Maker Auger Drive Gear – Replacement Part (3D Model)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Motor gear for Ice maker with Auger motor model SEAA260A01.

Rating
5 / 5
Likes
4
Downloads
60
Makes
1
Views
228
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

This model is a replacement auger drive gear used in refrigerator ice dispenser assemblies. The gear transfers torque from the auger motor to the ice auger, enabling ice to be conveyed from the ice bin to the dispenser chute.

The original part commonly fails due to plastic fatigue, cracking around the hub, or stripped internal drive features, especially under repeated load or ice jams. This replacement model restores functionality without requiring full auger or motor replacement.

Key Features

  • Designed to interface with a square-shaft auger drive

  • Straight-cut gear profile matching OEM geometry

  • Reinforced hub area to reduce cracking and premature failure

  • Suitable for left-hand ice maker auger assemblies

  • Optimized for 3D printing with minimal support requirements

Common Symptoms of Failure

  • Ice maker motor runs but auger does not turn

  • Clicking or grinding noise from dispenser

  • Cracked or split gear hub

  • Ice not dispensing despite motor operation

Printing Recommendations

  • Material: PETG, Nylon, or ABS (PLA not recommended due to brittleness)

  • Infill: 50–100% (higher infill recommended for durability)

  • Layer height: 0.2 mm or finer

  • Orientation: Flat face down for concentric strength

  • Post-processing: Light deburring of teeth and hub recommended

Notes

  • This is a non-OEM replacement design

  • Verify dimensions against your original gear before installation

  • Intended for repair and personal use

Tags