Dr Leaf Vacuum Anti-Clog High Performance Hose Adapter 6" to 5" (MOD)

⚠ COMPATIBILITY WARNING: READ BEFORE BUYING ⚠
This adapter is designed for a 5-inch aftermarket hose!!!

This is a tested hose adapter design, made to fit the Dr. series leaf vacuums, with a 6" inlet. It engages the impeller safety properly, and will disengage the button if the hose breaks way. Tight fit on the inlet, but that's intended, so it stays firmly in place. The PETG insert is for rigidity, allowing the two hose clamps to be tightly engaged onto the vacuum side of the hose.

Adapter Dimensions:
Inner Diameter Inlet: 4.5"
Outer Diameter Inlet: 5"
Inner Diameter Outlet: 6"
Outer Diameter Outlet: 6.25"

Uses:
Adapts to vacuum's inlet (6") to a larger, aftermarket 5" vacuum hose

Tags:
Dr. Series Leaf Vacuum Hose Adapter Cuff Performance Mod

Terms of Use: While I test for durability, I cannot control your printer calibration, material quality, or usage conditions. Therefore, these files are provided with zero warranties, express or implied. The user assumes full responsibility for any outcome, including injury or damage, resulting from the use of these files

3D printing settings

Print settings for outer shell:
TPU 95A
A dialed in printer
3-4 walls
18%+ 3D infill pattern (Like cross hatch or gyroid)
5 top and bottom layers
under quality, switch wall generator to arachne
Print slowly, I printed at 6.5mm³ flow rate, but even slower would result in a stronger part.

Print settings for inner ring:
3-4 walls
35% 3D infill pattern (Like cross hatch or gyroid)
5 top and bottom walls
under quality, switch wall generator to arachne

Requirements:
3 Hose Clamps
TPU 95A
PETG

ASSEMBLY
Insert the PETG ring into the TPU housing.

Included with your purchase:
stl files for both parts