1 / 2
*updated* Tennisball raiser for front wheel on indoor trainer (25mm to 45mm) — zdjęcie 1
1 / 2

*updated* Tennisball raiser for front wheel on indoor trainer (25mm to 45mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Raise the front wheel for your indoor trainer, the same way as the back.

Ocena
3 / 5
Polubienia
24
Pobrania
233
Wydruki
1
Wyświetlenia
1169
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Indoor Sports
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

On my Wahoo Kickr Core, mounted on Tennisballs, I always felt that my hands have a lot more stress, as on the street. After a bit of thinking it was clear to me that I raised the backend by about 50% of the height of a Tennisball, but not the front.

I know there are a lot of static front wheel mounts, but if I have Tennisballs on the back which can move in all directions, I didn't want the the front static wheel mount to rub over my floor, or limit the Tennisball movement with rubber under the front mount.

Therefor I designed this.

Fitting Tennisball raiser for the Wahoo Kickr Core can be found here.

See the updates in the differences section below!

Print notes:

I printed it with 0.4mm nozzle MK4S 0.28mm Draft Profile, Snug Support everywhere and 10% gyroid infill, using PETG, but PLA should also be fine.

Tagi