Emergency shutoff cover plate for standard Decora switch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Decora style switch cover plate for easier turn off.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 150
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted to make the "OFF" part of a switch bigger so it was easier to hit on a router table I was building. I didn't want to buy a new switch for this, so I made a plate that replaces the regular decora style switch.
The ONFrame.stl gets glued to the ONButton.stl. Then that assembly gets glued to the "On" half of the decora switch.
The decora switch I used is this one:
https://a.co/d/caPrs3m
You can buy them in black, but I painted the switch I had on hand black so it looked more like the emergency switch I was trying to replicate. I masked off the part that would take the "On" assembly so the that glue had a better chance of sticking.
The screws at the top are 3/4" 6-32 screws. I made the plate tabs a little wider in the final version (Render.jpg) so the screws don't stick out like you see in the photo (photo1.jpg).
The stop extension (STOPExtention.stl) gets glued onto the rectangular cube on the back of the stop switch panel (STOP.stl) to make the panel tip out a little further. I didn't add it to the panel itself so that printing can be a lot easier.
Other than the paint the switch is not modified at all so it will be just as safe as if the cover wasn't replaced.
Dec 29, 2025
Updated CoverPlate.stl to have a small lip on the backside to take up depth of switch mounting metal. Note this will likely require support to be enabled if printing face up.
Added CoverPlateThinner.stl. It is only 2mm thick rather than the 5mm thickness of CoverPlate.stl.